"The syntax of the command is incorrect" message logged

Previous Topic Next Topic
 
classic Classic list List threaded Threaded
3 messages Options
Reply | Threaded
Open this post in threaded view
|

"The syntax of the command is incorrect" message logged

Tim Brodie

Hi,

In the past few days, I've noticed the message "The syntax of the command is incorrect" being logged and I'm unable to locate the cause.

I'm running ASSP version 2.5.4(16318) on Windows 2008R2, Perl 5.20.2, mySQL v5.6.33.

This message shows up during the processing of some messages, but there doesn't seem to be a visible adverse effect that I can figure out (I'm sure there is though).

Recommendations of how best to determine where the problem is?

Thanks!

Tim



------------------------------------------------------------------------------

_______________________________________________
Assp-test mailing list
[hidden email]
https://lists.sourceforge.net/lists/listinfo/assp-test
Reply | Threaded
Open this post in threaded view
|

Re: "The syntax of the command is incorrect" message logged

Tim Brodie

Perhaps I need to run a debug session with an IDE to find out what error is happening where? Any recommendations for IDE/toolset that runs on Windows? Any ideas about why I'm seeing these logged messages?

Thanks.


On 11/15/16 12:09 PM, Tim Brodie wrote:

Hi,

In the past few days, I've noticed the message "The syntax of the command is incorrect" being logged and I'm unable to locate the cause.

I'm running ASSP version 2.5.4(16318) on Windows 2008R2, Perl 5.20.2, mySQL v5.6.33.

This message shows up during the processing of some messages, but there doesn't seem to be a visible adverse effect that I can figure out (I'm sure there is though).

Recommendations of how best to determine where the problem is?

Thanks!

Tim




------------------------------------------------------------------------------

_______________________________________________
Assp-test mailing list
[hidden email]
https://lists.sourceforge.net/lists/listinfo/assp-test
Reply | Threaded
Open this post in threaded view
|

Re: "The syntax of the command is incorrect" message logged

Andrew Porter-3
On 17/11/16 23:20, Tim Brodie wrote:
>
> Perhaps I need to run a debug session with an IDE to find out what
> error is happening where? Any recommendations for IDE/toolset that
> runs on Windows? Any ideas about why I'm seeing these logged messages?
>


I've seen this on SSL connections - the actual email was accepted ok but
the connection has, what must be, some garbage or nonsense after the .

On a qmail MTA this results in a load of unimplemented errors.

------------------------------------------------------------------------------
_______________________________________________
Assp-test mailing list
[hidden email]
https://lists.sourceforge.net/lists/listinfo/assp-test